Design forum
Showing results for 
Search instead for 
Did you mean: 

Curtain Wall in Section

Not applicable
I have a vertically butt glazed curtain wall. I have not been able to get the Horizontial Mullions to show in section. All I see is the solid area where the mullion should be if it passed thru or intersected the glass. I have tried all of the control settings. Any ideas?

try this ---->

failing that, can you post a screenshot?

(also - make sure that you don't have two overlapping objects: their contours can sometimes cancel each other out . . .)

b e n f r o s t
b f [a t ] p l a n b a r c h i t e c t u r e [d o t] n z
archicad | sketchup! | coffeecup

Not applicable
I am having problems getting the top and bottom Horizontial Mullion to show at the proper length and width. It shows as a square instead of showing 1.5x5.5" like the other horizontal mullions. I have not figured out how to send a section.

Didn't find the answer? Start a new discussion


Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!