Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Foundation not properly cutting into Mesh

Anonymous
Not applicable
Hi All;
Slight issue with only 1 of my 5 section cuts for this project. 4 of them display correctly per attached screenshot, the 5th one does not. Anybody any ideas what would make the foundation not properly cut the mesh?

Thx,
Marc
3 REPLIES 3
DGSketcher
Legend
Pick the mesh then go rt-clk > Display Order > "send to back"
Apple iMac Intel i9 / macOS Sonoma / AC27UKI (most recent builds.. if they work)
Laszlo Nagy
Community Admin
Community Admin
Did you perform Solid Element operation with the Mesh as Target and the Foundation as Operator?
Loving Archicad since 1995 - Find Archicad Tips at x.com/laszlonagy
AMD Ryzen9 5900X CPU, 64 GB RAM 3600 MHz, Nvidia GTX 1060 6GB, 500 GB NVMe SSD
2x28" (2560x1440), Windows 10 PRO ENG, Ac20-Ac27
Anonymous
Not applicable
DGSketcher wrote:
Pick the mesh then go rt-clk > Display Order > "send to back"
That was it. Thx a lot.

Did not use the solid element operators for that.

M