Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Have a problem Trim a Column with profile using SEO and TTR

Anonymous
Not applicable
Hi All, i have a problem when i trim column object with special profile.
there's a hole inside a column (see in a rec circle). anyone can solve this problem please?
Sorry my english is bad

trimproblem.jpg
2 REPLIES 2
Laszlo Nagy
Community Admin
Community Admin
It is kind of hard to figure out what is going on there because there are so many segments but:
You could also try to use a Solid Element Operation, with the object as Target, the Roof as Operator and using the "Subtraction with Upward Extrusion" SEO method.
Loving Archicad since 1995 - Find Archicad Tips at x.com/laszlonagy
AMD Ryzen9 5900X CPU, 64 GB RAM 3600 MHz, Nvidia GTX 1060 6GB, 500 GB NVMe SSD
2x28" (2560x1440), Windows 10 PRO ENG, Ac20-Ac27
Anonymous
Not applicable
Thank u Lazlo, i also try that way too and still have the problem but this day i get a solution...Thanks God, it just need to change Junction Order value fro 12 to 8 or below in the beam setting