Modeling
About Archicad's design tools, element connections, modeling concepts, etc.
SOLVED!

Magicwanding a closed polygon to morph lines?

Is there any way of magicwanding a closed polygon into morph lines (I think not), or exploding the morph surface into its morph perimeter lines/polygon, or somehow obtaining the morph linear segments/outline only? I am manually tracing stuff when I need the 3D outlines instead of the surface/volumes, and if there is no better way I wish there were.

1 ACCEPTED SOLUTION

Accepted Solutions
Solution
ryejuan
Advisor
 

ryejuan_1-1673400329342.png

use this method then once you have created your morph element you can press and hold CTRL+SHIFT then click and delete the solid face of the morph to retain the morph lines only.

 

In the end what is your Objective?
ArchiCAD 9 onwards

View solution in original post

2 REPLIES 2
Solution
ryejuan
Advisor
 

ryejuan_1-1673400329342.png

use this method then once you have created your morph element you can press and hold CTRL+SHIFT then click and delete the solid face of the morph to retain the morph lines only.

 

In the end what is your Objective?
ArchiCAD 9 onwards

That does the job. Morph, you're so pretty, the way you are. Thanks ryejuan.