I have a bunch of geometry in rhino drawn from z=0. So that when I send it to archicad the geometry ends up as morphs at sealevel or that is elevation 0.
The weird thing is that instead of just putting the geometry at 0 and setting the morphs home story to 0 it sets it to x and then adds a big +/- offset. I cant figure out where this comes from. The offset and story it is set to also changes! Look picture to see.
I cant see any way of using the grasshopper story setting with morphs.
I tried tampering with the morph story settings in archicad(setting to lvl 0 with 0 offsett) then starting up grasshopper again. The funny thing was that it didnt go to 0 or story 3(which was the story it had before) but it sent it to story 8! hehe.
Really really weird!