Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Stair problem

Anonymous
Not applicable
Hello everyone!
How can I create a stair like this? I always get the same message,
cannot create stair with this line of travel,

not so odd stair.jpg
4 REPLIES 4
Barry Kelly
Moderator
See attached image.
Barry.
One of the forum moderators.
Versions 6.5 to 27
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11
Anonymous
Not applicable
Yes you were right!!!
It did it when I added the new edge but....
I discovered this is not the stair I wanted since it creates "rests" I dont know the word in english, it only creates straight risers, I want risers that turn so as the stair to have risers without stops - rests.
I tried to curve the line of travel but then it says cannot create stair with this line of travel
Anonymous
Not applicable
"rests" I think you mean landings?

So you don't want any landings at the corners?
Anonymous
Not applicable
Maysum wrote:
"rests" I think you mean landings?

So you don't want any landings at the corners?
Yes thank you! I dont want the landings!