Design forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Vertical Line/Wall

Eman
Participant
Hi,

By mistake I changed a setting that I cannot find which one it is. I changed a setting that when I draw a vertical line or wall and then I enter the length, the dimensions that I enter goes into x coordinate and not in y coordinate. So the line/wall always rotate to an angle.

Thanks in advance.
Eman / Draftsman
Works at an Architects Company using ArchiCad 21
Intel(R) Core(TM) i5-6500 CPU @ 3.20GHz 3.19 GHz, 8.00 GB, 64-bit operating system, x64-based processor
1 ACCEPTED SOLUTION

Solution
insideru
Advocate
It's polar vs x-y coordinates. Default shortcut slash ( / ).
Or go to tracker options, first item.
ARCHICAD 24 INT
macOS Big Sur

View solution in original post

2 REPLIES 2

Solution
insideru
Advocate
It's polar vs x-y coordinates. Default shortcut slash ( / ).
Or go to tracker options, first item.
ARCHICAD 24 INT
macOS Big Sur

View solution in original post

Eman
Participant
Hi insideru, thanks very very much
Eman / Draftsman
Works at an Architects Company using ArchiCad 21
Intel(R) Core(TM) i5-6500 CPU @ 3.20GHz 3.19 GHz, 8.00 GB, 64-bit operating system, x64-based processor

Didn't find the answer? Start a new discussion

Labels

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!