Modeling
About Archicad's design tools, element connections, modeling concepts, etc.
SOLVED!

Walls go to Far....

Eric Milberger
Advocate

This happens every now and again

When I extend a wall it will extend itself to the other side of the wall - no matter where I touch that wall.

W5.PNG

Eric Milberger, Architect | Master Planner
2 ACCEPTED SOLUTIONS

Accepted Solutions
Solution
DGSketcher
Legend

You need to check your Building Material strengths. Priority based connections will apply and extend the wall at least as far as the reference line and sometimes further depending on strength values. 

Apple iMac Intel i9 / macOS Sonoma / AC27UKI (most recent builds.. if they work)

View solution in original post

Solution

Thanks  - it was the strength.

Eric Milberger, Architect | Master Planner

View solution in original post

2 REPLIES 2
Solution
DGSketcher
Legend

You need to check your Building Material strengths. Priority based connections will apply and extend the wall at least as far as the reference line and sometimes further depending on strength values. 

Apple iMac Intel i9 / macOS Sonoma / AC27UKI (most recent builds.. if they work)
Solution

Thanks  - it was the strength.

Eric Milberger, Architect | Master Planner