cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
search
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
BIM Coordinator Program (INT) April 22, 2024

Find the next step in your career as a Graphisoft Certified BIM Coordinator!

Enroll now
Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Why can't bend radiuses be reduced lesser than pipe diameters in MEP Preferences dialogue?

Narendra
Booster

‎2022-02-16 04:05 PM

Hello,

I am trying to reduce bend radiuses lesser than the pipe diameters in MEP preferences which would match manufacturer's products. Kindly refer to the picture of the form below.

Narendra_0-1644990902835.png

However I can increase the diameter than that of the pipe but cannot reduce it than that of pipe.

For example if pipe dia is 100mm it is not possible to change the bend radius to 60mm. Archicad allows that in the MEP custom settings dialogue for Bend element. Please see the figure, where I have made radius to 51mm for 100mm dia pipe.

Narendra_1-1644991272250.png

This causes a great inconvenience while routing.

Will someone show the way?

Thanks and Regards.

 

Naraindrra

Archicad Ver 5-25

 

Labels:
0 Likes
0 REPLIES 0
Learn and get certified!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!

Create new topic