Design forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

lovly corners for my box

i made walls, then created a very simple angle piece using the profile editor. then made a slap to fill in the top. the only problem is, the profile is jumping onto of itself on the corners. any ideas guys ? thanks. Ian

pixpast by Newcomer
  • 965 Views
  • 1 replies
  • 0 likes

Jumping doors

We've got a weird situation in our team project. This morning we discovered that quite a few doors have moved a little bit (100-200mm). Almost all structural walls that used to stop at the slab edge now are aligned to the inside of the exterior wall....

SEO and cut slab wont show on my plans

I have used a PROFILE to create this floor structure. Then on plan i created a slab in the shape of the cut i want. Used SEO and subtracted the new slab from the extruded profile. I got exactly what I wanted. The only thing that is annoying me. On pl...

pixpast by Newcomer
  • 3743 Views
  • 7 replies
  • 0 likes

new GRID wont show in new layers.

I just created a new grid system and it showns on the first floor plan that i had opened. but i cant see it any where on my other floor plans ? what am i doing wrong ? Thanks guys. Ian

pixpast by Newcomer
  • 1694 Views
  • 4 replies
  • 0 likes

MULTIPLANE ROOF LIMITATIONS

Hi. I was wondering if this (see attachment) was possible using the multi-plane roof tool. If so, please describe the process. It's too bad that you cannot edit the nodes along a hip in this instance. Doing it with single plane roofs gets tricky with...

lasse by Newcomer
  • 2626 Views
  • 4 replies
  • 0 likes

how do i precisely input 3d cut plane values?

In v14, when trying to input a precise value for a cut plane (e.g. EXACTLY 6'-3" A.F.F.) you could 1) hover the cursor above one of the top two windows in the 3D Cutting Planes dialog box, 2) press 'Z' and 3) input the correct elevation. in v15, this...

Bill by Newcomer
  • 7187 Views
  • 12 replies
  • 0 likes

How to hide walls?

Sup, ArchiCAD community. I've been using AutoDesk products the last three years, so I'm used with their settings etc. Now I'm doing a solo ArchiCAD-project in school, and I've come across some annoying features (in my opinion, of course.) Is there an...

Noktok by Newcomer
  • 5717 Views
  • 2 replies
  • 0 likes

Didn't find the answer? Start a new discussion