Have just started using the composite wall and skin feature in AC17 on a new job I'm starting. When I went to add a door I found that it won't go in there. I get the little arrows at the corners of the jambs, but when I click to install the door noth...
I thought it might help noobs & experienced users alike if there was a thread to share tips and tricks along the lines of "If only I had known this it could have saved me a lot of time!". It is not intended as a wish list or a debating ground for wor...
Hi, I am a student and I am trying to make a wall and curve it afterwards. The wall should have a hole and vertical wooden stripes attached to it (with equal spacing between stripes). Please see the picture, I tried to explain it visually. LINK TO PI...
I am trying to get a simple door and window reveal using ArchiCAD doors and windows right out of the library. The reveal is as shown in the image below. How can I set my doors and windows to get this reveal? This seems like it should be so easy but I...
Hi, I am having trouble getting slabs to show cut lines and cut fills in plan, for some reason they are showing uncut lines instead. All walls are showing cut lines and fills, but not slabs. I am working in Archicad 17, and the cutting plane is defin...
I would like to make a GDL Object using two Morphs. I would like to make one of the components rotate around an A-symmetrical point within the library part. I tried to figure it out using the GDL Guide but it was confusing and I am not sure where to ...
I have two walls adjacent to each other, one with a rectangular hole, the other with a window. The hole shows in plan but the window doesn't. I can see the window in 3d. I have played around with all the parameters I can, and the floor plan cut plane...
Edit Leaving this up just in case anyone else does the same dumb thing I did. --- Found it. Walls were drawn on the ArchiCAD Layer which was changing priorities in the different layer sets. Setting walls to a proper (non-master) layer did the trick. ...
Hello, Does anybody know if it is possible to have educational Archicad installed on two computers ? I recently bought desktop computer and would like to work on it, however I would also like to keep license on my laptop computer that I used for some...
Graphisoft has created the following presentation to commemorate the 30 years of ArchiCAD: http://archicad.com/ On the site you will see a chronological breakdown of the most important events in the company's 30 year history by clicking on various po...
