GDL
About building parametric objects with GDL.
SOLVED!

Make Section View only show cutted geometry on the cutting plane

Martin Walter
Enthusiast
I'm using a 3D geometry made up from EXTRUDE commands for the section view.
But the section always shows a lot of lines that are not directy cut by the cutting plane. These lines are from geometry behind the cutting plane.
I already played with the masks of the EXTRUDE command. But I can not see any difference using different masks.

Is there a way to only show the cutted geometry that is on the cutting plane?
(left is the actual section view - right the desired view)
AC23, Windows 10, i7-6700HQ, 8Gb RAM, 500Gb SSD
11 REPLIES 11
Lingwisyer
Guru
Change your line Status to 1 in the Extrude to hide lateral edges?

AC22-23 AUS 7000Help Those Help You - Add a Signature
Self-taught, bend it till it breaksCreating a Thread
Win10 | R5 2600 | 16GB | GTX1660 
Martin Walter
Enthusiast
Lingwisyer wrote:
Change your line Status to 1 in the Extrude to hide lateral edges?
Yes that is the solution of course!
AC23, Windows 10, i7-6700HQ, 8Gb RAM, 500Gb SSD