Document & Visualize forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Changing the units i elevation

Kamelite
Participant
I'm pretty sure this is a simple thing, I just can't seem to figure it out.

In the picture below, I have an elevation, and I need to label those windows with dimensions. So far so good. But I want to display them as decimeter-values, so that the label shows 10*19 instead of 990mm*1880mm..

[attachment=0]vindusdimensjoner.jpg[/attachment]

How do I make this happen?

.Thnx, Kamelite
Windows 10, archicad 24
1 REPLY 1

Kamelite:

If that is the Dimension Label 23, go to the Symbol Label Custom Settings > General Settings... tab, it has Show Units > Linear > mm, cm, dm, m, inch and by Project Preference options.

David
David Maudlin / Architect
www.davidmaudlin.com
Digital Architecture
AC24 USA • iMac 27" 4.0GHz Quad-core i7 | 24 gb ram • MacBook Pro 2.8GHz | 16 gb ram • OSX10.14.6

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!