cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Document & Visualize forum

Is it possible to have two types of detail drawings in one detail drawing?

LeeJaeYoung
Advisor

 

I have to cut a detail drawing from one floor plan and make two detail drawings.
One is the form that meets the window stmap and zone stamp,
The second should be a drawing without both and a zone label.
However, no matter what I do, only one detail drawing is made.

 

I can't, so I'm making a detail on the 5th floor
The same thing was made and used on the 6th floor.
The 5th and 6th floors are identical.

AC25 5010 / AC26 4019 on window 11
2 REPLIES 2

Andrii Levko
Expert

If I understand correct, you should to use the Model View Option and View Map. Create an MVO for each variants, and then create 2 different views in the View Map assigning them the correct MVO.

5.JPG

In view settings choose for your view correct MVO

6.JPG

Andrii
AC 8.1 - 25 INT/POL 5010

LeeJaeYoung
Advisor

 

LeeJaeYoung_2-1658633987451.pngLeeJaeYoung_3-1658634036228.pngLeeJaeYoung_4-1658634087050.png

Create one detail in Ground
I created two details with save as view...
And set each mvo.
However, it is determined by the mvo on the ground, and the two details are in the same view.

This question is asked because I think that the meaning of save as view... is meaningless.

As one detail, I need a window stamp and a zone stamp appear, a window stamp and no zone stamp, and a zone stamp and a section mark.
In other words, you need 3 different views with one detail.

I can't, so I create each detail on a different layer and use it separately.
Is this the right way?

AC25 5010 / AC26 4019 on window 11

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!