cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Document & Visualize forum

Placing renders in layouts??

Anonymous
Not applicable
its a newbie question but i haven't found the workflow yet. How can i store renders internally and place them on layouts?
Also if the model changes i have to go to each saved render and re-render each one?
1 ACCEPTED SOLUTION
4 REPLIES 4

Solution
Stress Co_
Advisor
Save a 3D View like you would save any view.

From the Project map, select the Generic Perspective from the 3D heading
(I'm assuming it's a perspective view).
Be sure to set "Generate in:" to Photorendering Window.

Place the saved view (from the View map) to a layout.

The view can be set to manually or automatically update on the layout.

Make sense?
Marc Corney, Architect
Red Canoe Architecture, P. A.

Mac OS 10.15.7 (Catalina)
Processor: 3.6 GHz 8-Core Intel Core i9
Memory: 48 GB 2667 MHz DDR4
Graphics: Radeon Pro 580X 8GB
ArchiCAD 25 (5010 USA Full)

Lingwisyer
Legend
Pretty sure it will re-render every time you go to that layout, so you should probably set it to manually update.



Ling.

AC22-23 AUS 7000Help Those Help You - Add a Signature
Self-taught, bend it till it breaksCreating a Thread
Win10 | R5 2600 | 16GB | GTX1660 

Anonymous
Not applicable
Thanks! I will try that! Because I was running out of time I just saved the renders to disk and then drag n drop them to my layout.

Lingwisyer
Legend
papsphilip wrote:
saved the renders to disk

It is probably better to do this then saving it internally as then you have access to the renders for other documents, post work and such.



Ling.

AC22-23 AUS 7000Help Those Help You - Add a Signature
Self-taught, bend it till it breaksCreating a Thread
Win10 | R5 2600 | 16GB | GTX1660 

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!