cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Document & Visualize forum

Resolution dropoff when printing from AC10 to HP 1055 CM

Anonymous
Not applicable
We are having problems when printing from AC10 (Mactel 1188) to a HP1055 CM using the print command. The resolution on our printouts is dropping off in portions of the printout, while in other portions the resolution is just fine. This is affecting fills and lineweights, where parts of the drawing are crisp and legible while others are fuzzy and faded. Our initial thought was that the plotter was the problem, but after a session with our plotter technician and installing new drivers, the problem persists. Has anyone else experienced this, and if so what can we do to fix the problem?
2 REPLIES 2

Djordje
Mentor
How much memory does your HP have?
Djordje



ArchiCAD since 4.55 ... 1995
HP Omen

Anonymous
Not applicable
128 MB, which is the most memory the plotter can accommodate to the best of my knowledge.

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!