Document & Visualize forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Returned wall end unwanted line between skins

Kinzy
Participant

As said in the title, while using the wall end tool, it creates an unwanted line between the outer skins where there should be none.

Kinzy_0-1652167979156.png

Kinzy_1-1652168004222.png

Kinzy_2-1652168033898.png

*Note: Line between identical fills is not the problem.

 

4 REPLIES 4

mija
Booster

If you turn off the line between identical fills does it go away?

It doesn't.

BrunoH
Booster

Hi,

The line appears because the material off the 2 faces aren't the same and or the 2 surfaces aren't the same. If it's possible for you to set the inside and the outside skins of the composite wall with the same material, then the line will be removed. Otherwise you can place a column with a complexe profile to replace the wall end.

ricorick
Participant

Thanks for helping with this question!

Start a new conversation!

Labels

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!