Documentation
About Archicad's documenting tools, views, model filtering, layouts, publishing, etc.

Roof Slope is Not Correct

Eric Milberger
Advocate
On hte attached - I have placed a truss which matches a dashed line - both drawn at 4/12 slop
The roof is also drawn at what is shown as 4/12 but is NOT at 4/12
Eric Milberger, Architect | Master Planner
3 REPLIES 3
Eric Milberger
Advocate
Here is the picture
Eric Milberger, Architect | Master Planner
Barry Kelly
Moderator
Roof pitch can be input as an degrees or percentage.
How did you input a 4/12 pitch?

You can use the pet palette in section to adjust the pitch to match the truss/line.

Barry.
One of the forum moderators.
Versions 6.5 to 27
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11
Eric Milberger
Advocate
I put in the pitch. Something was stuck in the element that was created.

I created another and it worked fine. I compared all info boxes and all were the same with different results.
Eric Milberger, Architect | Master Planner