Why is my roof showing the outline of the wall roof intersection. Both wall and roof are of the same generic exterior wall materials, basic wall format with no skins and with the same intersection number? When I did the original model the intersection was clean showing only the roof finish. What setting has changed?
Barry wrote: Either use a building material in the roof that is stronger than the building material in the wall or do a Solid Element Operation instead of connect/trim to roof.
Thanks for the info. I tried Junction Order in Wall Settings with no luck, but Intersection Priority In Building Materials did the trick. I would never have never have found it without your instruction. Thanks again.
Yes, you are correct. I think I got mixed up on which material I was making stronger. One was called "Generic Building material" and the other "Generic Exterior Material". Glad to see it works as intended.
I had the same problem so I copied the material of the wall, made it a little bit stronger and used it for the roof. In 3D working great, but now in section I don't visualiza anymore the wall and the roof like the same material (ovviusly).