cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Document & Visualize forum

What should I do with the stairs in the structural drawing?

LeeJaeYoung
Advisor

In the structural drawing, the tread and riser should disappear first. How can this be done?

AC25 5010 on window 11
5 REPLIES 5

Andrii Levko
Advocate

Deselect "finish" in the stair settings dialog. Alternatively you can use Profile for riser and tread and select "Finish" for this components  in Profile Manager, and then select display "without finishes" in Partial Structure Display.

But as I have notice, it only works for 2D Sections and for 3D views, but doesn't works for 2D plans.

 

By the way, it would be nice if the Partial Structure Display had an impact on the display for 2D plans of the stairs structure as well.

Andrii
AC 8.1 - 25 INT/POL 5010

I'm working on version 25.
I don't understand, so please attach an image if possible.

 

LeeJaeYoung_0-1655124676602.png

If finish is off, tread & riser cannot be used.

AC25 5010 on window 11

Are you saying it can't be done on a floor plan?

AC25 5010 on window 11

You have to select  Profile Tread 25 in dialog settings and then apply your profile:

Step 1 and step 2

Tread.JPG

Then select "finish" for your component:

Step 3

Tread profile.JPG

 and then select display "without finishes" in Partial Structure Display.

But as I mentioned above, it only works for 2D Sections and for 3D views, but doesn't works for 2D plans:

Tread_1.JPGTread_2.JPGTread_3.JPGTread_4.JPG

Andrii
AC 8.1 - 25 INT/POL 5010

But remember, when you select "Without finishes", all components that have a "finish" marker in the project will disappear. So it is a solution for some simply cases only.

Andrii
AC 8.1 - 25 INT/POL 5010

Start a new conversation!

Labels

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!