cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Document & Visualize forum

Forum Posts

Dimension and Renovation Filter

I have been able to create dimensions just fine in my existing/renovation plan. Recently I have been getting this message every time I try to create a dimension in my Existing / Demolition plan. I check my renovation status and I dont see any option ...

dhnguyen by Contributor
  • 894 Views
  • 5 replies
  • 0 likes

White surfaces turn grey

Hi! I'm using Cinerender for quick interior renderings to show colour choices. However, the ceiling (and the walls as well) turn out very grey/dark. I'm not great at renderings, so I would like any tips or ideas on how to make the colours brighter. I...

Anonymous by Not applicable
  • 780 Views
  • 2 replies
  • 0 likes

Title Sheet Issue

I created two new Title Sheets (Architectural D, and Ledger sizes) in the Master Layout to use as my Master Title Sheets. However when I go into another project file I cannot find it in that list of Titles in the Master listing. The only Title Sheets...

Anonymous by Not applicable
  • 236 Views
  • 1 replies
  • 0 likes

Trimming roofs

I have a shed dormer that is on top of the main roof. I can't figure out how to trim the main roof so that it doesn't show up in the section. Please see attached images. Thanks

dhnguyen by Contributor
  • 365 Views
  • 3 replies
  • 0 likes

PDF Bloat

Yesterday I ran an Acrobat Pro 'optimize' on a 6 page pdf published from ARCHICAD 23. The published file was 28Mb. After the optimization it was 4Mb. Ran another this morning. Start was 44Mb, optimized to 7Mb. Booth these files have building elevatio...

Floor to Floor Dimension

Is there a way to automatically show the floor to floor dimension instead having to manually create a dimension string for it? I wasn't able to find it in the Elevation Settings. Please see attached. Thank you

dhnguyen by Contributor
  • 374 Views
  • 2 replies
  • 0 likes