cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Document & Visualize forum

Forum Posts

AC 11 "internal sun" settings

Hello Everybody, as there are a bunch of new settings for the Lightworks Sun (PhotoRendering Settings Dialog) i'd like to ask if there is any explanation for the settings. I discovered, that a soft shadow is produced after changing "Shadow Transparen...

Anonymous by Not applicable
  • 9566 Views
  • 10 replies
  • 0 likes

That old chestnut -

Hi All, I am currently faffing about with the attached rendering, and while searching about this forum have found many different opinions regarding your initial/basic Lightworks (for ArchiCAD 10) light setup before one starts to tweak settings. Am I ...

Anonymous by Not applicable
  • 2422 Views
  • 3 replies
  • 0 likes

HPGL.GPD for Archicad 10?

Hi All, I'm looking to run some plots on our draftmaster II, unfortunately AC10 doesn't seem to have it anymore (it has HPGL2.GPD however the draftmaster only understands HPGL not HPGL/2) - I know its old, but ..... Is there somewhere I can get the H...

Anonymous by Not applicable
  • 1786 Views
  • 1 replies
  • 0 likes

Materials

I would either like to make my own wall material, or would like to modify one of the materials that is already there. The material I would like to modify is the 8" vertical siding, I need to change the color. I would also like to make it 6", if I can...

Anonymous by Not applicable
  • 2856 Views
  • 3 replies
  • 0 likes

Light Cone Down 11 - Rendering issue

Hello! I'm using AC11 student edition and have in my model the 'light cone down 11' lamp object. this light is playing funny tricks with me: the only way i can get it to show in the LW rendering is to modify the shadow settings in the LW render setti...

Anonymous by Not applicable
  • 8138 Views
  • 9 replies
  • 0 likes

Masterbath.

Just finished. Modeled in Archicad, finalized in blender converted using blendigo rendered with indigo and adjusted with Violet. comments welcome.

Anonymous by Not applicable
  • 1534 Views
  • 1 replies
  • 0 likes

TEXTURES

Hi Fellow users. How do I add (install) new textures to archicad? Any special format required? Thanks Sedley Jeffers

sedley by Booster
  • 2595 Views
  • 3 replies
  • 0 likes

error code 545,555 and 635

Hi all, since a short while i get the warning when i look at my model in 3D... not enough memory to cut 3D model. (error code 545) then the same warning twice with error code 555 and 635 If i continue there seems to be nothing wrong with the model. I...

Anonymous by Not applicable
  • 1237 Views
  • 0 replies
  • 0 likes