cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Document & Visualize forum

scale format in placed drawings

Anonymous
Not applicable
Is it possible to change the scale format in automatically placed title blocks of drawings? The current format is say 1/4"=1'-0" or 1"=10'. I would like to change this to read 1:48 or 1:120 when the title block is placed.
3 REPLIES 3

Djordje
Mentor
william wrote:
Is it possible to change the scale format in automatically placed title blocks of drawings? The current format is say 1/4"=1'-0" or 1"=10'. I would like to change this to read 1:48 or 1:120 when the title block is placed.
Switch to Metric as units. Make sure to keep your dimensions in Imperial.
Djordje



ArchiCAD since 4.55 ... 1995
HP Omen

Anonymous
Not applicable
Thanks Djordje, as usual you make the seemingly complicated quite simple.

Ignacio
Advisor
william wrote:
Is it possible to change the scale format in automatically placed title blocks of drawings? The current format is say 1/4"=1'-0" or 1"=10'. I would like to change this to read 1:48 or 1:120 when the title block is placed.
I am curious. Why/where do you need to do that?

[If the drawing is going to be read by metric guys, the scales would be 1:50 and 1:125.]

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!