It's me again! This is a new slant on the seats in my project which WERE thankfully able to be inserted into my stadiums. The seat vendor was able to incorporate a circular piece of the stanshion for those seats that are on the end of the row that have a space to place a logo of 5 7/8" in diameter there. Before I start dragging copies of rows of seats all over creation, I thought it would be a good idea to place the logos on the ends of the rows BEFORE I copy them. When I DO copy the rows from one row to another up or down how will I handle the change in elevation, the logo will be at a different elevation than the bottom of the seat and will probably have to be edited separately for each row. I also want to add a row number inside the logo using the 3D TEXT tool that will also have to be edited separately. I am trying to resist using the MORPH tool to create these logos because my project's polygon count is out of hand and slowing things down. In an attempt to have a vertical surface to create the logo plate I built a wall that can be seen in 3D as well as section, and tried to crop that wall into a circular shape to which I can affix the logos you can also see in the section snip shot. Another concern I have is that in one of my stadiums the logo is of The Babe swinging for the fences. I can not simply mirror the logo on one side of the aisle to the other side without turning The Babe into a righty. Can you advise me if I am going down the wrong path to get to the right solution?
I will be out of my apartment for most of the day, and thus away from my computer, I should return by no later than 4:00 PM Eastern. If you are able to install v22 by this afternoon you can send the link and start the session anytime after 4:00. Looking forward to working with you.