Installation & update
About program installation and update, hardware, operating systems, setup, etc.

Different selected wall hotspots, settings question.

Anonymous
Not applicable
Hi,

My friends in the office have a different way of presenting walls when selected. Propably this way of presenting with additional hotspots on reference line and on corners of the walls seem to come from some old versions of Archicad, propably they have imported this way of presenting when upgrading software years ago.
The wall should be presented with only two hotspots and the ends of reference line when selected

Image below show how their walls are presented.

Where is the place to change the way selected walls are presented, I can't manage to find it ?

I think this "old" way of presenting walls causes problems with complex structure walls.

Przechwytywanie.JPG
1 REPLY 1
Anonymous
Not applicable
I've found the solution.

It's quite hidden, pretty difficult to guess this was the one to check: