Setup & License forum
Showing results for 
Search instead for 
Did you mean: 

Dimensioning goes crazy after changing the cut plane height.

Not applicable
The issue:
we are working on quite a big project with multiple floors that intersects each other. The differences of the stories are sometimes lower than the cut height. The output was that some of the windows, that are above the cutting plane, stopped showing on the floor plan. To get them back I have changed the cut plane height so it would catch the windows. Windows are now on, but the dimensioning went crazy. If I go back to the previous cutting height the dimensions are stil invalid. We have hotlinked modules in this project.



Minh Nguyen
Graphisoft Moderator
Graphisoft Moderator
Dear Piotr,

Thank you very much for sharing the issue and I am very sorry about the experience!

After some discussion, it looks like a defect to us, although it is not clear what is causing it at the moment. Is it possible for you to share the file (in PLA format) for further investigation? Please let me know if you will need a secure place to upload the file also.

Looking forward to hearing from you!

Best regards,

Minh Nguyen
Technical Support Engineer

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!