Strange line connection/junction problem

[Anonymous]

Hello,

I have an issue especially with lines and polylines in ArchiCAD. The problem appears only on arcs in junction. The example shows what I have in mind. It happens everywhere -> 2d/3d etc.

The line is correct but the look is weird. It's not a big issue but sometimes because of that I think something is wrong in my model.

FYI -> after printing lines are correct

[Anonymous]

zgredfryd wrote:
Hello,

I have an issue especially with lines and polylines in ArchiCAD. The problem appears only on arcs in junction. The example shows what I have in mind. It happens everywhere -> 2d/3d etc.

The line is correct but the look is weird. It's not a big issue but sometimes because of that I think something is wrong in my model.

FYI -> after printing lines are correct

I have the same probelm! Need remedy ASAP!