Setup & License forum
Showing results for 
Search instead for 
Did you mean: 

Thick lines in 3d, unable to select

Is there a solution to this issue? when working in 3d and zooming to the element (for example, trying to select the corner point), blue reference line becomes way to thick. It is almost impossible to navigate in that scenario. Is there any solution to always render line thickness same width, regardless of the zoom?
ArchiCAD 24

Nguyen Minh
Graphisoft Moderator
Graphisoft Moderator
Dear Petar,

Thank you for the question and I am very sorry about the experience!

Unfortunately, it is not possible to edit the reference line thickness.

However, if we set the Snap Guides on and position the mouse next to the desired corner, a blue circle will appear to assist accurate selection and replacement. Please find the Help Center article below:

Please let me know if it helps with the issue!

Best regards,

Minh Nguyen
Technical Support Engineer

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!