cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Setup & License forum

Forum Posts

Pen Set gets overwritten

I am encountering an interesting problem where ARCHICAD overwrites my Modelling pen set (coloured) with my Publishing pen set (B&W). This has happened often enough that I know it's not me, but too infrequently for me to figure out a cause. I have 6 p...

Bruce by Enthusiast
  • 4774 Views
  • 15 replies
  • 0 likes

AC 19 installation on mac machine with server

Hi, I want to install AC 19 on mac machine with codemeter for multiple users. The procedure is same as we install in windows machine or it will be differ. If it differs what is the procedure to install and work through the network (LAN). Please send ...

Roopa A by Contributor
  • 1377 Views
  • 0 replies
  • 0 likes

Computer restarts while working in 3D

First general information: I am working on my diploma thesis - an urban development project - so far I have modeled terrain consisting of about 45000 polygons (according to polycount add-on). The terrain is modeled from slabs using a magic wand to tr...

New Dell 15" computer

By the way I am thinking of buying the new 15" dell eps. Could you please post some comments about working and rendering with it. Thank you

Anonymous by Not applicable
  • 3180 Views
  • 7 replies
  • 0 likes

Fundemental flaw with gridline offset in Elevations

so I have found a pretty fundamental flaw with the gridline offset function when displaying gridlines in Elevations please refer to my attached screenshots below East Elevation - I have shown the gridline B with a 700 offset (to the right towards Sec...

Anonymous by Not applicable
  • 929 Views
  • 1 replies
  • 0 likes

ArchiCAD 20 slow & Cinerender crash - MY SOLUTIONS

Dear ArchiCAD Community. Before i used AC20 i used AC12. AC12 was very fast compared to vanilla AC20. I could type several keyboard commands in fast order and AC12 did them without hesitation. Panning and zooming was above average. 2D & 3D were fast....

Anonymous by Not applicable
  • 10388 Views
  • 10 replies
  • 0 likes

Archicad 21 solo edition updates

My software says that it isn't up to date, but when I go into the download/update page from Graphisoft there isn't anything for Solo Edition. I'm running build 3013. Also, is there a template for residential? I had heard that there is a template, but...

Anonymous by Not applicable
  • 1553 Views
  • 1 replies
  • 0 likes