godi wrote:
A brick wall 3 fills, as I think every material should be able to have:
The front is already separate.
That is controlled by the fill attached to the surface that you apply.
A wall can have 3 different surfaces - front, back and edges.
I guess it would be nice to have the edge surfaces split so top/bottom can be controlled separately to the sides, but Archicad does a fairly good job at wrapping the surfaces in the correct direction.
Beams already have 5 surfaces and slabs can have individual edges overridden.
It would be nice to have consistency among all elements.
But now I am going off topic from the original question about fills.
Yes, it would be great if plan and section fills could be different.
Surface fills we already have separate (but slightly limited) control over them.
Barry.
One of the forum moderators.
Versions 6.5 to 27
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11