Wishes forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Door relation to zones

ovt
Participant

I would like to enable a zone to extend across more rooms, therefore the doors should have an optional setting as not to be a zone boundary.

I  know I can set the walls relation to zones, but I need to set the doors realtions to zones because of the BoQ workflow.

4 REPLIES 4

Barry Kelly
Moderator

If you tell the wall 'not to be a zone boundary' or to 'reduce zone area only', the doors in that wall will still belong to the zone.

 

Barry.


One of the forum moderators.
Versions 6.5 to 25
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Dell Precision 3510 - i7 6820HQ @ 2.70GHz, 16GB RAM, AMD FirePro W5130M, Windows 10

ovt
Participant

Thanks. I know, but I need the walls to remain a boundary so they are considered in Walls Surface Area Schedule (for BoQ).

I don't do a lot of wall surface area scheduling.

Does the wall have to be a zone boundary for that schedule to work?

The wall should still belong to the zone.

Or is it specifically looking for walls (surfaces) attached to the zone boundary only?

 

Barry.


One of the forum moderators.
Versions 6.5 to 25
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Dell Precision 3510 - i7 6820HQ @ 2.70GHz, 16GB RAM, AMD FirePro W5130M, Windows 10

Yes, Walls Surface Area is a Zone parameter that is only considering boundary walls.

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!