Linetype selection for Individual Roof/Slab Edges

[Aaron Bourgoin]

If we can now assign an edge type to a roof - ridge, valley, hip, etc., could we also have te ability to assign a line type for individual edges.

Could this new behaviour extend to, or be associated with more inteligence where roofs/slabs pass over or under one another on the same story.

A classic example might be a dutch gable roof where a hip plane tucks under two gable planes.

An nice extra would be the option for these hidden edges to heed or ignore cover fills placed on the roof planes above them.

Tired of placing 2D dotted lines to "explain" or heed the conventions of 2D drafting. The line is there. You just can's see it. And if you can't see it, it should be dotted.