Wishes forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Place 'Area Calculations' in "Calculation Units & Rules'

Anonymous
Not applicable
To change the decimal tolerances for a Fill 'Show Area Text' it appeared that it would be under the Options > Project Preferences > Calculation Units & Rules > Area Unit . However it is located within the Dimensions category which, on the surface, is counter-intuitive to where to change the decimal tolerance level.

My wish:

Place the "Area Calculation" in the 'Calculation Units & Rules' drop-down of Project Preferences.
1 REPLY 1

I think it would be better if the two are combined, so there is only one place for these settings. See this thread where settings from both places appeared in one schedule: Interactive Schedule Units.

David
David Maudlin / Architect

www.davidmaudlin.com

Digital Architecture

AC24 USA • iMac 27" 4.0GHz Quad-core i7 | 24 gb ram • MacBook Pro 2.8GHz | 16 gb ram • OSX10.15.7

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!