Wishes forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Remove Sharp Corner of intersecting walls

nathanburkholder
Contributor

Hello,

 

I have two walls joining with one wall at a degree less than perpendicular to the other. When I intersect the two walls together, it creates a very sharp point. How can I make it so that there is no point? 

 

See image attached. 

 

Thank you.

 

nathan burkholder

Archicad 25.4013

Windows 11


Screenshot 2022-03-04 114607.png
2 ACCEPTED SOLUTIONS

Solution
Karl Ottenstein
Moderator

It's just showing what you modeled.  If you want a blunt end.. then you need a vertical wall at that point, but the intersection probably still won't clean up properly because, based on your surprise, I'm guessing that your wall reference lines are the inside of the angle.  If the reference lines are on the outside, then they will properly intersect and clean up with a very short vertical wall.  As many have said - model the way you would build it. 🙂

 

One of the forum moderators   •   AC 25 USA and earlier   •   MacOS 11.6.7, iMac Pro

View solution in original post

Solution
Laszlo Nagy
Community Admin
Community Admin

In such a case, I would model that Wall end as a Column with a Complex Profile so it will correctly heal with the Wall in Floor Plan and 3D, and classify it as a Wall so it will schedule/export properly.

 

....................................................................................................
Get Archicad Tips at https://twitter.com/laszlonagy
AMD Ryzen 1700X CPU, 48 GB RAM, Nvidia GTX 1060 6GB, 500 GB NVMe SSD
2x28" (2560x1440), WIN10 PRO ENG, AC20-AC25
Loving Archicad since 1995

View solution in original post

2 REPLIES 2

Solution
Karl Ottenstein
Moderator

It's just showing what you modeled.  If you want a blunt end.. then you need a vertical wall at that point, but the intersection probably still won't clean up properly because, based on your surprise, I'm guessing that your wall reference lines are the inside of the angle.  If the reference lines are on the outside, then they will properly intersect and clean up with a very short vertical wall.  As many have said - model the way you would build it. 🙂

 

One of the forum moderators   •   AC 25 USA and earlier   •   MacOS 11.6.7, iMac Pro

Solution
Laszlo Nagy
Community Admin
Community Admin

In such a case, I would model that Wall end as a Column with a Complex Profile so it will correctly heal with the Wall in Floor Plan and 3D, and classify it as a Wall so it will schedule/export properly.

 

....................................................................................................
Get Archicad Tips at https://twitter.com/laszlonagy
AMD Ryzen 1700X CPU, 48 GB RAM, Nvidia GTX 1060 6GB, 500 GB NVMe SSD
2x28" (2560x1440), WIN10 PRO ENG, AC20-AC25
Loving Archicad since 1995

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!