Wishes
Post your wishes about Graphisoft products: Archicad, BIMx, BIMcloud, and DDScad.

Snap feature for marquee

Anonymous
Not applicable
It would be good to have a way to keep walls, slabs, roofs etc, at square angles when using marquee to stretch. If you get the marquee through the wrong spot you may end up having a wall or slab at 163.41 degrees.
1 REPLY 1
Barry Kelly
Moderator
Make sure you have both end points of the straight edge of the element inside the marquee. If one of the end points is outside then it will not move and you will get elements on angles.
Use the irregular shaped marquee if needed.

Barry.
One of the forum moderators.
Versions 6.5 to 27
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11