cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Wishes forum

Forum Posts

Redshift render settings needed in help files.

I have just had the opportunity to test a machine with a decent graphics card that can make use of the Redshift render engine. I found that the images all seemed a little over-exposed, so I thought I would check out the HELP files to see if there was...

BarryKelly_0-1663051632082.png

window reveal line thickness in section

I can't find any setting to adjust reveal line thickness for a window in section. While everything looks neat in floor plans - where the wall reveal has covered thermal insulation and plaster finish layer, in a section I have several problems:1) I ha...

window_floor plan.JPG window_section.JPG

Resolved! Skylight Tools

I simply would like to put a skylight in my roof like this....Using the roof tool I put the composite roof on top of these beams and then added a layer of 1x6 timber between the metal sheeting up top.  Underneath I built a frame for the skylight. The...

Screen Shot 2022-09-11 at 12.49.30 AM.png Screen Shot 2022-09-11 at 12.54.17 AM.png Screen Shot 2022-09-11 at 12.55.01 AM.png
Paa by Booster
  • 333 Views
  • 4 replies
  • 0 likes

Archicad 26 review

I guess a review is another way of saying wishes, right? Here's my review of Archicad 26: http://www.shoegnome.com/2022/09/08/Archicad-26-review/

Resolved! Change floor maintaining position

On some occasions, when modeling in 3D, out of haste or comfort, I place objects or mep parts at heights much higher or lower than the floor level. So then they don't show up on the floor. When I change them to the corresponding floor these objects m...