cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Design forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! Trimmed wall and roof - floor plan

Hi everybody, we are designing a building with pitched roof and wall connections, where the bottom parts of the walls are trimmed. Is there any way to hide the trimmed part of the wall on the floor plan?

EAttila by Participant
  • 66 Views
  • 2 replies
  • 0 likes

How do I make this roof?

Hello. I'm trying to create the roof based on this irl picture and these 3d picutres. I have no idea how to create the dormers. Does anyone know a good way to achieve a result like the one on the pictures?If any one needs any further explaination or ...

322594746_556423099703107_6461777367427535447_n.png 323030086_2424439501027327_6649900319941634731_n.png 323092527_676988433907743_8441558587474322653_n.png 322944271_1581754045601659_6892517484143386085_n.png
mollens by Contributor
  • 135 Views
  • 2 replies
  • 1 likes

Roof trouble

Hello,I'm having trouble with changeing the materials of the roof or its thickness. I've been using "attic tiles" so far although i'd like to change to "full passive roof" (or any other kind). While doing that, the roof just disappears, same goes wit...

321686533_855629472384684_7011544054662125150_n.png 322070109_858305655411059_1432856807323662353_n.png
mollens by Contributor
  • 126 Views
  • 1 replies
  • 0 likes

Creating a Mansard Roof

Greetings to all Archicad oracles in this forum! So, this is the issue of the day: I want to create a simple mansard roof from a gabled roof. But for some reason it acts up.. How come? To make things worse, this roof has a third break to make it look...

Kamelite_0-1671443315333.png Kamelite_1-1671443755058.png

Resolved! Creating a roof to sit on walls at different heights

Hey I have a design of a small home on a sloping site where the floor and walls step up about 1m on the high side of the site. I want to create a single roof structure that covers both sides of the home. How can I, or is it even possible, to set the ...

PHIL7 by Contributor
  • 262 Views
  • 4 replies
  • 0 likes

Resolved! How to show hidden geometry in floor plan?

Hallo,In the drawing of foundation, I want to draw the thickenings of the foundation slab under the columns (with the whole geometry). For the thickenings I've used the slab tool with inclined edges (Custom Edge Settings). Is there any way to show al...

Resolved! Trim to roof - greater control?

Hi, I need advice with trimming the walls with roof in such a manner that I get a correct gable detail out of the box. Here is my situation: If I do the connect/trim elements to shell/roof i get the following result:As you can se the trim is not corr...

Rastisan_0-1669029949285.png Rastisan_1-1669030029605.png Rastisan_2-1669030221601.png

side walls in dormers?

hey everyone,i can't figure out how to trim, or create side walls for a roof dormer that are trimmed to the main roof slope, so that the walls don't extend down to the floor. see the pic attached. i i have tried trim to roof or shell, but the whole w...