Document & Visualize forum

Roof Slope is Not Correct

On hte attached - I have placed a truss which matches a dashed line - both drawn at 4/12 slop The roof is also drawn at what is shown as 4/12 but is NOT at 4/12

Dimension will not stick to wall

Both walls (attached images) will allow mw to select the walls for dimensioning, but the lower wall will not hold onto the dim. What might be happening? How can this be corrected?

Aiming to an efficient DWG export

Hello, I've been reading and testing a lot in order to create a DWG translator as clean as possible for our consultants. Overall they are satisfied with what we provide them but there is a couple of points I'd like to improve/understand better. I fee...

Resolved! Autotext problem between view & Layout - AC25

If any archicad sages could help I would really appreciate it. I have a few labels that I have created with auto text and 2D symbols that work fine in AC24 but are not working in AC25. The labels show perfectly fine in the view map but not in Layout....

Section and Elevation Markers

I have created sections and elevations not realizing they should show the current Name and sheet they are placed on. They have a Name A, B, etc and I would assume that would show now? And I assume the Page Number. When Placed on a sheet - I go back t...

Publisher PDF defaults

Is it possible to change the PDF defaults when setting up publisher sets and adding layouts to sets? I almost always need to add layouts to be published and AFAICT I need to check and set PDF options every single time.

WALL END TOOL

Good day All, I am having problem with the finish look of wall ending made with wall end tool. See attached image. Anyone has some suggestions? Thanks for you kind advices... Best

Horizontal tolerance issue for windows and doors in composite wall

Hello everyone, I am trying to create the custom window in the Library part maker, and when I insert it into the composite wall I get this problem with horizontal tolerance. Does anybody know if there is a way to exclude this part from horizontal tol...

ZONE STAMPS - not removing CA- Calculated Area

Using Version 25 I finally got my zones labels like I like them Room No Room Name Floor Walls Finish Size This looks great except in small room I need a label with only Room No Room Name Here is where my problem is Everytime it displays it provides a...

Resolved! Existing & Proposed ...

Hi, Let's say I have one existing ground floor drawing and one proposed ground floor drawing and I want to put them one on each other. Usually I copy the proposed drawing and paste it on the existing drawing. But which is the best way to do it? Becau...

Graphisoft Community

Forum Posts