cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Wishes forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! Change floor maintaining position

On some occasions, when modeling in 3D, out of haste or comfort, I place objects or mep parts at heights much higher or lower than the floor level. So then they don't show up on the floor. When I change them to the corresponding floor these objects m...

Symbolic cut option for complex profiles

I'd like to have an option within the profile manager where we could set a height at which the wall/column/beam would display as a symbolic cut. Most of our walls are complex profiles and sometimes I need a symbolic display. I like to avoid using cov...

Chris H by Contributor
  • 81 Views
  • 0 replies
  • 6 likes

Curtain Wall Divider

Please, add a tool to make it easier to split curtain walls, just like we can use Ctrl + Click to divide lines, walls, beams...

Resolved! Drag Slab in Section

In section you can currently "pull" / "stretch" walls & roofs in section, however, slabs can only be edited on floor plan. This would be helpful when we are having the use slabs as beams, as there is no polygonal beam/column option.

JackIPL by Contributor
  • 255 Views
  • 5 replies
  • 0 likes

Renovation Filter - Upgrade

i would suggest Graphisoft look into implementing these 2 upgrades to the renovation tool. as it would speed up and make workflows easier. 1. Allow elements to be Pinned on multiple renovation filters - ( create a drop down check list for the element...

Stairs in Hotlinked file lost Floor Plan Display Layout

Dear Delevopers, it's a long time since we have this issue in Archicad. When we set stairs Floor Plan Display Layout in original file, these informations are lost after use these file as a hotlink. It would be nice bake the Floor Plan Display Layout ...

OriginalStairs.png HotlinkStairs.png OriginalFile.png HotlinkedFile.png
Jakub N by Contributor
  • 152 Views
  • 2 replies
  • 2 likes

Elevator / Lift respect original storeys from Hotlinked file

Dear Developers, we had severals discussion with Archicad users in Czech Republic about Elevator object (also following this discussion ). It would be nice to have Elevator object which respect original storeys setting from Hotlinked file or which ca...

OriginalFile.png HostFile.png
Jakub N by Contributor
  • 171 Views
  • 0 replies
  • 10 likes

Gutter Object

It would be great if it were possible to add multiple outlets to the gutter outlet for larger commercial schemes. We can add multiple objects for the various downspout connection on the same run but it would be better if it were possible to add addit...

Place Door by inside edge of frame.

It would be great if it were possible to be able to place a door by the inside of the frame when converting survey data. Most surveyors still only provide 2D which we trace off and they measure the openings from inside face of frame to inside face of...

Labels