About Red

Red · 2024-02-07

It would be great to have a default AC shower that comes with an adjustable linear or trench drain. Nowadays, modern showers typically don't feature a center or corner drain, and even the round drain is becoming less common. Thoughts?

Red · 2023-10-05

Is there a way for the "Distance Guidelines" to reference each side of the core? I thought it might be able to by turning off the wall finishes, but it still goes to the finish as if it was still turned on.

Wallhole Cutting Through Complex Profile · 2023-09-28

Is there a way to prevent a wallhole from cutting out any trim that might overlap the openings? I was hoping that setting the "Opening Reference" would prevent it, but it does not seem to work either.

Red · 2023-08-28

I am hitting roadblocks with listing a variable's value when it sometimes has one or two conditions to determine the answer. I am trying a Sequence, but I know I am laying it out incorrectly, and I can not figure it out... I realize that by moving th...

Red · 2021-12-07

First off, I'm not too fond of a finish schedule like this, but I can not get him to adapt, in my opinion, the more modern way of showing it. I feel this style of finish schedule could cause a person to misread a finish, or even me to mess up drawing...

Red · 2023-11-30

I would go with a morph or a complex profile unless you need a stair object for a specific reason. I still use morphs more than not for stairs versus the stair object. It has gotten better, but not there just yet.

Red · 2023-11-30

I would not prefer that ability. For example, If Unit C changes, they all should be in my book. The only reason I say that is what if the next update is a major one and someone else is editing it, and they are not aware of certain Unit C updating and...

Red · 2023-10-05

If I use shadows, it is all or nothing; I have never had the need to show the same section with or without shadows. However, I see your point if you need that regularly. The only thing I could recommend is another Section Line. If I were representing...

Red · 2023-10-04

I have always been able to achieve the look I want through Grapical Overrides if needed, but that may not work for you with what you are trying to achieve.

Red · 2023-10-04

Unless I am missing something in your question, you can save Elevation/Section views in your View Sets with any setting you like with "View Settings".

User Statistics

User activity

Shower with adjustable linear/trench drain

Distance Guideline

Wallhole Cutting Through Complex Profile

Expression question

Finish Schedule - Older Method

Re: stairs with seperate (concrete) flight and landing

Re: Updating a single hotlink and not every hotlink in the entire project

Re: Elevation Display settings

Re: Elevation Display settings

Re: Elevation Display settings