Hi,I copied a series of Concrete columns, for some reason, all the
copied columns have no Outline in Section I've looked at the pen & fill
properties, but I can't see a difference btw them. The columns are all
aligned across section. Please see attac...
Hi,I've added a mesh, and set the nodes relative to each other - taking
the lowest point as zero. Then I've set Sea Level to x.x mtrs. The
Elevation markers reflect this. Now. When (in site plan), I place a Spot
level marker on the mesh - it only sho...
Hi, Is there a way to create a plane parallel or coincident to side of
the roof. I'm trying to sketch the outside edge of the side of roof - on
that plane (or perpendicular to it), so I can save it as a .DWG I'm
trying to create a physical model of t...
Hi,This I'm guessing is a common problem,But - I've changed the home
storey of a wall, by creating a lower level (NGL) and setting ext walls
that.But I can't see the walls on FL level? I've changed the "Floor Plan
cut Plan Settings" to 1 level above,...
HIThat's pretty nifty poco2013, you've used Python to extract the actual
zone area "value(s)" and populate an array from it, then show it in
Archicad. The Data is there, you've clearly shown that. But why can't we
do the same thing using Archicad dir...
Hi tomyg,Here how's (in detail) I created a percentage of site areas.
(See attached). But yes, Archicad allows you create a new property, but
you can not capture a single zone area "value" as a stand alone
property. I'm not an expert in Archicad - bu...