Hello, I primarily work on conservation projects in the office, meaning
for the majority of projects I rely largely on the 2D functionality of
archicad rather than 3D. One of the primary stages on most projects is a
detailed overmark of elevations / ...
Afternoon all, Just a quickie. I'm setting up BIM Server in our office
and have got it backing up to our server to a general BIM server folder.
However, we are looking to have each project back up to a separate
location on the server, is this possibl...
Hello all, Over the last few days I have sent 4x 3D prints of sections
taken from an Archicad model into both HP and Makerbot 3D Printers. The
HP was having issues with inverted surfaces created by the integration
of elements in composite walls, wind...
Good afternoon all, I'm looking for a suggestion as to how to remedy the
issue of correctly orientating a roof texture, without having to split
the roof into two individual pitches. Does anyone have any
recommendations? Cheers, Scott
Afternoon all, I'm trying to trim zones to roofs to take into
Ecodesigner*. But the SOE won't trim the zone to the rooflight and the
attempting to connect the zone and roof removes the zone entirely. Any
advice would be appreciated. Best Regards, Sco...
@BarryKelly Yeah, saving direct to STL from Archicad. Also analysed the
model using Meshlab, Netfabb and SketchUP to look at the surfaces. These
applications allow you to see the surface conflicts that Archicad
generates where something that is an ou...