It has been said to draw in your normal scale in AC such as 1/4" then to
change your output scale in PM as you need it for the different size
drawings such as D or tabloid. This seems fine until you update a
drawing, then PM reverts the AC drawing ba...
I thought there was a way to get hairline printing output from setting
the output to hairlines in Plotmaker. The plotmaker option I find says
its a screen only control not a printing control. I finally managed to
get my first cd book together in plot...
I have the same problem with a hp 755cm and a mac. I can't get it to
print to the 36". So far I've given up and print on 24" roll paper. I
hope some one on this forum can give us some insight. It is as if the
printer doesn't know its 36" wide. My plo...
I'm having the same problem with plotmaker using the templet included
with AC. I tried making smaller margins. Under deadline I printed a
"off" set for the Building department knowing they don't use rulers. It
seems buggy to me. There is lots of unus...
At that point it would be better to show the individual floor joists and
beams, sub floor, finish floor and ceiling below, especially in section
drawings. What's the best way to make this transition? I make my floor
slabs height equal to the framing ...