Is there a way to use Autotext for add 'Last Update or Revision' on a
title block? Is there a simple way to grab the file created and modified
date, similar to using 'System > Date' in autotext. I've also not got my
head around the Layout Revision se...
How would I create this roof shape, not even sure I've titled it right?
this was quickly done in Sketchup.. Originally I tried using a slab for
the flat section then a roof squashed as much as I could, but just
looked wrong in 3D and elevation. I've ...
I seem to have ended up with to many points in my section marker (not
even sure how I added them). How to I remove/reduce the number of points
in AC20 without deleting the section marker and starting again.
I don't know, but is this possible within ArchiCAD (I know a lot can be
done with the right knowledge!)? I know there is an MEP modeller but I
never looked at it or know if that would do underfloor heating pipe runs
like in the plan above. Would this...
@Marc H, good point! Most councils will know how to use Adobe measure
tool or have a ruler with the common scales on it. What do you mean
'Eric Bobrow’s AMT use of a simple 1”' is this just disclaimer text you
add to your title block?
Lingwisyer wrote: If you go for a scale bar that scales with a view, you
just convert glob_scale into the relevant factors. In regards to using a
drawing title, you should probably use ac_drawingScale over
ac_originalDrawingScale as this will prevent...
So I think I over complicated it. On my Complex Profile I removed the
flat section leaving just the pitch at the front then used Solid
Operations to clean up. This seems to work, but open to better