Cadimage surface slider
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-03-10 10:05 PM
2020-03-10
10:05 PM
The main door frame should be offset and extend where the last door stacks.
Example Images attached
2 REPLIES 2
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-03-11 10:55 PM
2020-03-11
10:55 PM
Could you model this using the exterior trim?
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-03-11 11:29 PM
2020-03-11
11:29 PM
Possible, I'll take a look, it should however move the main frame to the outside and not leave it in the wall where regular slider would have it. I don't know how this gets past Cadimage, do they look at real life doors when they code this?