cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Documentation
About Archicad's documenting tools, views, model filtering, layouts, publishing, etc.

Forum Posts

Section and Elevation Markers

I have created sections and elevations not realizing they should show the current Name and sheet they are placed on. They have a Name A, B, etc and I would assume that would show now? And I assume the Page Number. When Placed on a sheet - I go back t...

Publisher PDF defaults

Is it possible to change the PDF defaults when setting up publisher sets and adding layouts to sets? I almost always need to add layouts to be published and AFAICT I need to check and set PDF options every single time.

JohnJay by Expert
  • 641 Views
  • 5 replies
  • 0 likes

ZONE STAMPS - not removing CA- Calculated Area

Using Version 25 I finally got my zones labels like I like them Room No Room Name Floor Walls Finish Size This looks great except in small room I need a label with only Room No Room Name Here is where my problem is Everytime it displays it provides a...

Resolved! Existing & Proposed ...

Hi, Let's say I have one existing ground floor drawing and one proposed ground floor drawing and I want to put them one on each other. Usually I copy the proposed drawing and paste it on the existing drawing. But which is the best way to do it? Becau...

Eman by Contributor
  • 2191 Views
  • 10 replies
  • 0 likes

How do I remove these from my elevations

Cant figure out how i did this ! but i want to remove the end points from my drawings ! turn off... I dont know what there called . Just learning cheers

Anonymous by Not applicable
  • 780 Views
  • 2 replies
  • 0 likes

Complex Profile in Plan

I have created a complex profile for a foundation with a knee wall (image 1). Image 2 shows how the foundation in plan with the footer shown with continuous lines. However, I want the footer to be dashed lines as shown in image 3. Is there a setting ...

Anonymous by Not applicable
  • 825 Views
  • 4 replies
  • 0 likes

Archicad 24 - issues with label tool between view and sheet

Hello everyone I'm having an annoying issue in Archicad 24. We have been adding certain standard notes (2x4 WD Studs @ 24in OC, for example) in the 'Project Info', and using Autotext to add them to our details using the Label tool. The problem is tha...

jrmrt by Contributor
  • 1160 Views
  • 2 replies
  • 0 likes

Archicad 25 Door/Window Markers displaying "Custom ___ by ___"

Hi all, Recently downloaded Archicad 25 and I'm having this issue with the Door and Window Markers. All I want is for the doors and windows to only display either (E) or (N) as I will set in the marker settings. However, no matter what parameter I ch...