Got a minute? We appreciate your feedback:

Graphisoft Learn survey
Documentation
About Archicad's documenting tools, views, model filtering, layouts, publishing, etc.

Forum Posts

Resolved! Plan flawed representation

Hello everyone, I have the following problem: I have a roof that intersects 2 inclined walls and it doesn't show up right in my plan view, although in 3D everything seems to be just fine. For some reason, the intersection line doesn't show up in the ...

Anonymous
Anonymous
  • 1248 Views
  • 2 replies
  • 0 likes

Surface Label bug with wall direction

I've discovered a bug with the Surface Label (22 & 23) that makes it unreliable in practical usage: it will read the opposite of the wall if the wall direction is flipped. Try it: 1. Draw a wall with different surfaces outside and inside 2. Apply the...

Bruce Expert
  • 882 Views
  • 4 replies
  • 0 likes

Change N/A settings in Worksheet View

How do I permanently change either the Structural Display, the Graphic Override, or the Renovation Filter in a Worksheet? I can change these settings in the Worksheet itself (and I get the warning dialog), but these do not change the View Settings - ...

Bruce Expert
  • 456 Views
  • 0 replies
  • 0 likes

Drawing frames extremely faint

In AC22 the drawing frames were a nice clear dashed line. In AC23 they have changed it so it is a very faint dotted line. I turn drawing frames on and off to align my drawings on the Layout but with this new drawing frame line type it is quite hard t...

Anonymous
Anonymous
  • 822 Views
  • 5 replies
  • 0 likes

PLANS

I have an blown up section plan that I am doing and also a corresponding Reflected ceiling plan. How do I make sure (for lack of better words) view ports are the same size on each page that I need to add ? For example i would like that the plan and t...

Anonymous
Anonymous
  • 531 Views
  • 2 replies
  • 0 likes