on
2018-02-22
08:43 AM
- edited on
2021-11-10
01:03 PM
by
Noemi Balogh
Affected versions: Archicad 20 | Severity: workaround applicable | ID: 241225
Issue:
The cursor in Archicad 20 build 7001 became dislocated, making it hard to work accurately, if the display is scaled up (larger than 100%) in Display Settings.
This means that the hotspot of the cursor is always distanced from the tip of it, it is not where it seems to be. This is what it looks like:
Click on the square symbol in the lower right corner to watch the video in full screen.
Cause:
The images used for displaying the many different types of cursors were not scaled up properly following the scaling of the screen. Certain coordinates of these images are also incorrect.
Workaround:
If you run into this issue, these are the options you can consider choosing from:
Please note that if you keep in mind that the actual cursor is a bit distanced from where it appears and you pay attention to the feedback of the cursor, you can still work precisely.