Installation & update
About program installation and update, hardware, operating systems, setup, etc.

Forum Posts

Archicad Crashed

i was designing a sink and then ArchiCAD constantly crashes, and keep crashing while I try to change the surface for an object. It has happened both in views, as well as when I try to pick a surface in Surface Settings. Is anyone else having the same...

Anonymous by Not applicable
  • 1278 Views
  • 0 replies
  • 0 likes

New Notebook.

I want do buy a new Notebook with an i7 but i don't know how good the graphic card is. It's a Geforce GTX 960M with 4GB. Does anxone use this card and can tell me sone facts?

Anonymous by Not applicable
  • 2468 Views
  • 2 replies
  • 0 likes

Magic Mouse scrolling too Sensitive Under Sierra

Has anyone (who uses a Magic Mouse) noticed that after installing Sierra the scrolling acts like it is on steroids? I turned the "inertia" off, but still, the scrolling is so fast and dramatic is it hard to use. I might need to go back to MagicPrefs ...

Archicad and files on separate HDD partitions?

Hi all, I am currently in the process of cleaning up and reorganising my PC. I'm using a Dell XPS 15, running windows 10 with a 1TB hard drive. Currently, everything is saved to the C Drive, but my understanding is that I should be creating a separat...

Anonymous by Not applicable
  • 2221 Views
  • 1 replies
  • 0 likes

AC20 MOUSE SELECTION SETTING KEEPS CHANGING BACK

AC20 selection setting keeps changing back to "partial selection", even though i have: -set it to direction dependent -redefine, save and reapply every "work environment profile" sub settings, and set them as default. etc. -close AC20 and then reopen...

Anonymous by Not applicable
  • 1198 Views
  • 1 replies
  • 0 likes

keyboard shortcuts vanish when I open a project again?

I have been working on a project and simultaneously building a project template alongside it, so I thought I was saving all my custom shortcuts every time I saved either the template or the project. I re opened them each and my short cuts are gone. T...

Deati Marker / Worksheet magnet selection

I do remember there was a discussion about it but I was not able to dig up. Detail Marker and worksheet came around AC10 (?) Now we are at 20 and still it is recognized by the magnet. If there is a zone stamp under it or slab it is very hard to selec...

Anonymous by Not applicable
  • 1176 Views
  • 0 replies
  • 0 likes

Slow DWG publishing after AC19 7006 update

Dear All, Please confirm if it is just me or you have slower DWG publishing after 7006 update under 19. I'm experiencing ~1.5x - 2x slower dwg publishing time. Rebuild of layout is fast, than conversion takes time, than file saving fast.

Anonymous by Not applicable
  • 1664 Views
  • 2 replies
  • 0 likes