Stair railing display
I have created a stair using AC10 generic stair tool, not stair maker, and I cannot get the railings to show up in plan view. Everything is good in Elevation and 3D. How do I fix this with?
Forum Posts
Do the Mark-Up Tools work?
The tools within the Mark-Up palette remain grayed-out regardless of active tool or selection -- is it broken?
Three Buttons for One Tool - Sections, Elevations + Int Elev
Three tools for the same procedure, might it have not been better to create a tag to choose from in the S/E tool panel? I.E. group with: elevations sections interior elevations ____ Imagine how I will teach this 3 tools to my next group of students i...
AC11-Terrain tool doesn't show cut in floor plan with SEO
Trying new things and decided to use SEO's on a terrain to see if/how it works. Either with cover fills on or off it doesn't show the hole.
Window's mullions floor plan display
Hello everybody. Can anybody help me to make the window's mullions show in floor plan? (I've attached a printscreen describing the issue) I have to mention that both 2D & 3D detail levels are set to "detailed". Thank you Adi Tudoreanu
Tip - heap zone errors
On new windows computers with enough RAM and no other reasons for a memory shortage, you may get a message: "Cannot save plan file, not enough room in heap zone." Rather than spending hours trying to resolve and losing information, because of inabili...
Tip - heap zone errors
On new windows computers with enough RAM and no other reasons for a memory shortage, you may get a message: "Cannot save plan file, not enough room in heap zone." Rather than spending hours trying to resolve and losing information, because of inabili...
print bitmap pattern in ArchiCAD 10
Hello, I worked a lot with bitmap patterns in archicad 9. after opening my old AC 9 files in AC 10 I can see my old bitmap patterns perfectly but I cannot print them. I understand that AC 10 only prints Vectorial hatching. Why? What am I supposed to ...
Composite Wall Fills to scale correctly in plan
Hello everyone, I have a problem to show correctly a fill on my composite walls (AC8.1) in plan view. I have placed Batt Insulation on one of them, nothing fancy, but when it is placed on the drawing it stays as shown on the fill and does not scale t...
smart facade tool
Hallo, Do you use Smart Facade Tool? Can you help me how to set interspace (distance) among facade boards? Thanks
Start a new conversation!
